SNB-PX24 PLANER MANUAL
9
6/2016
4)
Up and down adjustment for delivery roller and press roller.
The positions of the bearing of the delivery roller and press roller have been factory
adjusted. If bearings to the right or left become uneven, the user can loosen the four
fastening nuts under the bearing so that outer diameter of the delivery roller and press
roller are positioned over the blade shaft by about 1mm. Tighten the four fastening
nuts after adjustment (Graph D).
Graph D
5)
Up and down adjustment of the holding roller on work table:
a)
The Up and Down adjustment for the holding roller on work table has been factory
adjusted. The user can loosen the four fastening nuts under the work table for
readjustment. Revolve those four adjustable nuts to position the outer diameter of
the holding roller over the table by about 0.01~0.2mm. Tighten the four fastening
nuts after adjustment (Graph D-above).
b)
Maintaining a parallel line between work table and blade shaft:
The work table and blade shaft adjusted to be parallel to each other. The user can
loosen the two fastening bolts at the pedestal for readjustment. Revolve the
pedestal screw left or right to move the table up or down, then tighten the fastening
bolts after adjustment.
6)
Up and down adjustment (for blade shaft) of breaker and press roller:
The up and down adjustment for blade shaft by breaker and press roller have been factory
adjusted. The user can adjust the position of two adjustable bolts to the left and right sides
of the breaker for readjustment.
Additionally, adjust the position of the two adjustable bolts positioned to the left and right
side of the press roller then continue to follow instructions below:
Summary of Contents for SNB-PX24
Page 1: ...SNB PX24 25 PLANER MANUAL...
