SNB-K2A AUTOMATIC EDGE BANDER MANUAL
9
6/2016
1
2
3
4
5
6
7
8
Fig. 5
5.
Make sure edge strip is clean with no oil contamination, tool marks or cracks.
Caution: Don
’
t run the machine until the temperature reaches 400
°
F,
default factory
glue temperature setting is 400
°
F
.
CONTROL PANEL
The functions of the control panel shown in Fig.5 are as follows:
1.
Main switch:
Off is
0
and On
1
; controls the machines power supply; digital thermometer
lights up. Turn the Key to the
ON
position and the machine is ready to operate. The
machine will not start up without opening the control system with the key.
2.
Trimming and cutting components: designed to trim the upper and lower edge
overhang. Off is
0
and On
1
.
3.
Automatic side-by-side end cut components are designed to cut before and after the
edge overhang, there are two buttons which control the rotation of the milling cutters,
Off is
0
and On
1
.
4.
Automatic belt conveying device: Off is
0
and On
1
.
5.
The top button is a time relay that controls the length of the edge strip being fed, and
the bottom button controls rotation of the glue roller and moves the edge strip. Off is
0
and On
1
.
6.
The meter on top indicates and controls the glue temperature. The bottom right button
is the heater switch. Off is
0
and On
1
. The lower left is a signal lamp, which indicates
that the switch is On and ready to operate.
7.
Emergency switch: once the switch is impelled all functions will stop immediately, and
the switch is in a locked state. You have to turn the knob to the right to restore electric
transmission.
