Too damp or wet
1.
Connect LP gas tank per “Connecting LP Gas Tank” instructions.
Caution: Keep this appliance area clear and free from combustible materials,
gasoline, other flammable vapors and liquids and open flames.
2.
Turn LP ga
s tank valve slowly to “OPEN.”
3.
Press and hold control valve button (Figure 4).
4.
IMMEDIATELY press and hold igniter button down until you hear a “POP”
sound indicating ignition. Normally occurs within 20 seconds.
5.
Continue to hold control valve button for 30 seconds.
6.
You know ignition is complete when the needle on the engine gauge begin to
move into the
“Green” zone.
Engine not functioning properly
LP gas tank is low or empty
Exchange, refill or replace LP gas tank
LP gas leak
Follow “Checking for Leaks” instructions.
Ventilation blocked
1.
Turn off LP gas tank per “Turning Off” instructions.
2.
Disconnect LP gas tank per “Disconnecting LP Gas Tank” instructions.
3.
Check ventilation openings and air-inlet to make sure clear of debris.
4.
Clean SkeeterVac per “Cleaning and Care” instructions.
Product turns off suddenly
Out of gas
Exchange, refill or replace LP gas tank
Overheat protection switch (heat sensor) turned ON
1.
Turn off LP gas tank per “Turning Off” instructions.
2.
Disc
onnect LP gas tank per “Disconnecting LP Gas Tank” instructions.
3.
Let engine cool for 30-45 minutes.
4.
Connect LP gas tank per “Connecting LP Gas Tank” instructions.
5.
Light product
per “Lighting” instructions.
6.
After 5 minutes of operation, verify LED lights and fan are working properly.
For more assistance, please visit MrBarBQProducts.com or call 1.888.398.8643.
(end of Owner’s Manual label)