chemicals).
•
Minimum clearance from sides and back of unit to combustible construction is
91.4 cm (36 inches). Do NOT use this appliance under any type of overhang
or roof.
•
It is essential to keep the
product’s valve compartment and circulating air
passages clean.
•
Inspect product before each use.
•
Do NOT alter product in any manner. Any alteration will void your warranty.
•
Do NOT use the product unless it is COMPLETELY assembled and all parts are
securely fastened and tightened.
•
This product should be thoroughly cleaned and inspected on a regular
basis.
Clean and inspect the hose assembly before each use of the
appliance. If there is evidence of abrasion, wear, cuts or leaks, the hose
assembly must be replaced prior to operation. Also inspect for damage
and wear during each maintenance cycle. Never operate if parts are
damaged, missing or improperly installed.
•
Use only the regulator and hose assembly provided. Use only the
replacement regulator and hose assembly specified by Mr. Bar-B-Q
Products LLC.
•
Do not hang clothing or other flammable materials either on or near the
product.
•
Use only Mr. Bar-B-Q Products LLC factory-authorized parts. The use of
any part that is not factory-authorized can be dangerous and will void your
warranty.
•
D
o NOT operate this appliance without reading “Operating Instructions” in this
manual.
•
Do NOT install or use in or on boats or recreational vehicles.
•
Do NOT use this product in high winds.
•
Never lean over the product when lighting.
•
Keep children and pets away from the product at all times.
•
Do not allow children to operate or play near the product when it is in use.
•
If at any time you are unable to light the product and smell gas, shut gas off at
cylinder, wait 5 minutes to allow gas to dissipate before attempting to
relight the product.
•
Failure to not wait 5 minutes to allow the gas to clear if the product does not
light, may result in an explosive flame-up.
•
Do NOT place anything on the product.
•
Do NOT attempt to move the product when in use.
•
LP gas cylinder must be properly disconnected and removed prior to moving
this product.
•
Storage of the product indoors is permissible only if the cylinder is
disconnected, removed from the product and properly stored outdoors.
•
Do NOT attempt to disconnect the gas regulator from the cylinder or any gas
fitting while the product is in use.
•
Always place this product on a hard, non-combustible, level surface. An asphalt
or blacktop surface may not be acceptable for this purpose.