BOATING SAFETY
1-23
If the Skeeter boat is to be left in the water after use, leave the bilge pump switch in the ON position. The
pump will activate if needed to drain any water accumulating in the bilge.
Drain Plug: A drain plug is located at the center of the stern to allow more complete draining when the boat
is removed from the water.
Lights
Check for proper operation of the bow, stern, and instrument lights by pressing the switch on the control
panel. If the stern light is not installed, remove it from the storage area, lift the socket cover, and install it into
the socket to check operation.
Horn
Press the horn switch to be sure the horn operates.
Fuel and Oil
Follow your outboard motor owner’s manual for information about the proper fuel and oil for your motor.
Engine Stop Switch
First, place the boat in the water to provide adequate engine cooling. Start the engine, and then remove the
engine stop switch clip, and verify that the engine stops. See your outboard motor owner’s manual for more
information.
Section 1_horiz 11/3/03 2:40 PM Page 1-23
