Operation
Button Sequence
Buttons must be pressed in the sequence
shown.
or
= Press individually
[
] = Press both simultaneously
= Security code, press in sequence
Operating the Pump
• To activate LED:
Press and hold
for 2 seconds.
• To check battery status:
With the LED on
, press
.
Battery Status Indicators
Full charge; approximately 75% to 100% battery capacity
remaining.
Battery is charged enough to operate the pump;
approximately 25% to 75% battery capacity remaining.
Battery charge is low (charge battery); approximately
1% to 25% battery capacity remaining.
Low Battery Fault. Pump will stop running, beep, and
go to sleep in 10 seconds.
• To operate from AC power:
The QuickTake 15 may be run using AC power with the AC charger/
adapter with battery. Insert the charger plug into the jack on the pump
and the charger into a standard wall outlet. Operate the pump.
The charge light on the LED will flash if the battery is charging during AC
operation.
The AC charger/adapter can be used to extend battery run time, but it is not a
battery eliminator. Therefore, it will not provide indefinite run times.
