SKAARHOJ Eth-SDI Link
SDI Shield
The Eth-SDI Link uses the Blackmagic Design 3G-SDI Shield. The Blackmagic 3G-SDI Arduino Shield
supports the following formats using SDI Level B:
720p50, 720p59.94, 720p60, 1080i50, 1080i59.94,
1080i60, 1080p23.98, 1080p24, 1080p25, 1080p29.97, 1080p30, 1080p50 (output only), 1080p59.94
(output only) and 1080p60 (output only), but the camera doesn´t have to be running the same video
format as the program input, so you can use cameras in Ultra HD while the camera protocol is sent over
HD signal to the camera.
Troubleshooting
Error on Check: Your controller is not yet registered
After pressing Update Firmware a message from the Firmware Updater stating that the connected
controller is not fully registered yet may pop up. The Eth-SDI Link uses Stand Alone firmware and is not
updated through the “Update Firmware” button on the firmware updater.
To upload the latest Eth-SDI Link firmware please see the “Updating Firmware” section of this manual.
If trying to change the IP address for the Eth-SDI Link please see the “IP Config” section of this manual.
9
