External Microphone
Off
Date / Time
Gimbal Control
Off
Frequency
60Hz
Default Setting
Display ISO
Off
CAUTION:
• Make sure the grey rubber seals
behind the access doors are present,
aligned and set properly.
• Check for hair, dirt, dust, or other
debris that may get caught between
the doors and the camera body as
they may cause a slow leak that may
eventually flood the inside when
fully submerged.
• Always check that both the ba ery
and USB port doors are closed shut
all the me.
• Always wash the camera housing
with clean freshwater a er every
dive to rinse off any salts or other
contaminants. Keep both access
doors closed while doing this.
• Wipe off excess water
with a clean cloth then air-dry.
Once dry, open and clean the doors.
Note:
For dives deeper than 5 Meters,
it is important to use a waterproof
housing specifically designed for the
S10. Sold separately.
EXTERNAL MICROPHONE
• Enables or disables external microphone.
External microphone must be inserted first into the USB slot (sold separately).
DATE / TIME
• Sets camera system date and time. Files will be labeled according to the
setting here. Date / Time will also appear when Time Stamp is enabled.
GIMBAL CONTROL
• Enables or disables camera buttons being controlled from the gimbal.
FREQUENCY
• Sets the screen refresh rate. This setting is dependent on country’s electricity
Alternating Current (AC) standards.
May also be used to counter screen flicker or wagon-wheel effect.
DEFAULT SETTING
• Resets all the camera’s settings to factory defaults.
DISPLAY ISO
• Enables or disables displaying ISO setting information on the main screen.
GENERAL SETTINGS - Page 3
All graphics, words, and design by Troy Ferrer 2020 [email protected]
