25
CHAPTER 6
ADJUSTMENT, PREPARATION AND USE
6.1
INTRODUCTION
1) Connection to the tractor is highly dangerous. Take great care and carry out the entire operation in
strict compliance with the following instructions.
2) Nobody should go near the area between the tractor and the machine.
3) Check that all warning and danger signs are in place and legible.
4) Check that the tractor is in good running order.
5) Check the engine oil, gearbox oil, brake fluid and cooling water levels as well as the tire pressures.
6) Refer to the tractor operator's manual.
6.2
MOUNTING
TO THE
TRACTOR
In order to fasten the ma-
chine to the tractor, insert
reverse gear so that the
tractor draw-bar matches
coupling 5 on the ma-
chine, and insert the pin to
fasten into position. To
enable the tractor hook to
pass through coupling 5
on the machine, move
foot 3. When the machine
has been assembled, its
frame should be parallel
to the ground so coupling
5 can be assembled in ei-
ther position A or position
B by using two of the four
holes F.
After having attached the
machine, loosen foot 3 and remove it and place it on the rest bushing. Hook the hydraulic clutch to the tractor
and place the cable near the driving seat.
ADJUSTMENT, PREPARATION AND USE
