To report any issues with this product, please contact our customer service department at (888) 274-8664.
For more information, visit www.sitonit.net
EBEAM ASSEMBLY INSTRUCTIONS
STEPS
Dept.
Technical reference
14
16
15
14. Remove the ¼"–20 × 1¼" screw and ¼"–20 × ¼" hex nut from the pre-attached hose clamp assembly.
15. Position the hose clamp above one of the bottom slots and fasten it to the thread feature on the upper inside of beam
with a #10–24 × ⅜” screw using the ⅛" hex L-key.
16. Hold the power infeed within the hose clamp opening and slide the ¼"–20 × 1¼" screw through the hose clamp holes.
Then tighten the ¼"–20 × ¼" hex nut onto the screw using a #2 Phillips screwdriver.
Connection to building wiring must be done by a qualified electrician.
See page 23 for 4-2-2 wiring schematic.
Power Infeed
Bottom Slot
9
