To report any issues with this product, please contact our customer service department at (888) 274-8664.
For more information, visit www.sitonit.net
EBEAM ASSEMBLY INSTRUCTIONS
STEPS
Beam is shown upside-down.
Beam is shown upside-down.
Beam is shown upside-down.
Beam is shown upside-down.
Beam is shown upside-down.
Beam is shown upside-down.
Beam is shown upside-down.
10
11
10.
If legs share mounting plates with the wire tray(s):
Slide in one mounting plate per leg and align them to the outer wire
tray tabs. (Use this installation option with the mounting plate closest to the infeed when using a 48" beam.)
If legs do not share mounting plates with the wire tray:
Slide in one mounting plate for each leg and set of wire tray tabs.
The mounting plates for the legs can be placed inside or outside the wire trays' outer mounting plates.
Note: Leave at least a 3" gap in the bottom slot for the infeed and ¾" spacing from the open ends of the beam for the end
caps. Some mounting plates or screws may be left over after installation.
11. Place the legs in position and use the
3
⁄
16
" L-hex key to secure the legs and outer wire tray mounting plates in place with two
5
⁄
16
"–18 × ¾" per mounting bracket. Turn beam upright. Note: Legs can be mounted in two different directions.
SEPARATE MOUNTING PLATE
SHARED MOUNTING PLATES
Mounting Plate for Leg
Mounting Plate for Wire Tray(s)
MOUNTING PLATE FACES IN
MOUNTING PLATE FACES OUT
SHARED MOUNTING PLATE
Wire Tray Tabs
7
