SISTEM AIR Industrial Clean Basic, Technical Manual

Page: 99 / 384

21
2
15/02/12 Rev:1.0.0
English
10.2 Electric connection ( see also following paragraphs )
Before connecting the system to the electrical power supply check that the supply voltage corresponds
to that required by the appliance (see the identifi cation plate).
The manufacturer declines any responsibility for damages to persons and/or objects due to a connec-
tion to a non-complying electric wiring.
Follow the instructions (see picture) detailed below to carry out the operation:
• Connect the input signal cable (MICRO LINE 1) to the suction inlets.
• Connect the output signal cable (MICRO LINE 2) to the electric motor. Should the motors be more
than one, connect the cable to the Sistem Air’s electrical panel.
• Check that the electric installation is made according to the electric regulations in force.
•
It is not recommended to supply the vacuum unit with tension coming from temporary power
panels (for example building sites’ power panels) in order to avoid possible damages of elec-
tronic parts.
WARNING: the electrical connection must be carried out
ONLY by qualifi ed personnel.
Micro line 1: suction inlets connection
12 V
Micro line 2: connection electric motors
(see “Industrial Motor” manual)
RJ45 connector for
optional Ethernet
interface connection
Line Supply 230V ac
Connector for the Autocleaner
device connection
Serial connection for electronic motors.