Industrial Clean instruction manual
52
15/02/12 Rev:1.0.0
11.3.3.8 Check and test Menu
Through this menu it is possible to check if the suction system is working properly.
Installation check
This menu is to be used to calibrate the vacuum breaker valve with reference to the nominal current of
the motor group selected with serial address nr. 1 (see Industrial Motor manual).
INSTALLATION PARAM.
DATA TRANSMISSION
RESET PARAMETERS
TRIAL AND TEST
PRESS ENTER
˄˅
INSTALLATION TRIAL
SUCTION INLET TEST
AUTOCLEANER TEST
ELECTRONICS TEST
PRESS ENTER
˄˅
INSTALLATION TRIAL
SUCTION INLET TEST
AUTOCLEANER TEST
ELECTRONICS TEST
PRESS ENTER
˄˅
INSTALLATION TRIAL
ACTIVATE PROCEDURE
YES
NO
< > PRESS ENTER
Press
Enter
to access the submenus.
1
Use the
up
and
down
arrows to select
the menu.
Press
Enter
to access.
2
IT IS RECOMMENDED NOT TO CARRY
OUT ANY OPERATION INSIDE THIS
MENU, UNLESS YOU ARE ASSISTED
BY AUTHORISED SISTEM AIR’S PER-
SONNEL.
1
Use the
right
and
left
arrows to make the
selection.
Press
Enter
to confi rm and move onto
the next screen display.
2
Summary of Contents for Industrial Clean Basic
