This manual is the property of SISER S.r.l., any even partial reproduction is forbidden
Mod. PRD 20/3 - Last updating 10/2019
TS-One Manual for use and maintenance
44
TS
ONE
5
EN
When the machine is turned on the display shows the actual temperature of the platen and the
LED L1<TEMPERATURE> is on
Setting the Time
Working Temperature
Press P1 <Set> again and the settings will be saved. The display returns to the initial screen
showing the current temperature.
Pressure
5.3 Heat Application
Place the fabric on the lower platen, taking care to lay it evenly, avoiding any creasing.
For the temperature and transfer time, follow the manufacturer’s instructions of the transfer
material.
Having completed the work, switch off the press, bringing the main switch to position 0 (OFF).
Caution: always keep the two platens separated when not in use.
Caution: the buzzer signals time is up, however the machine does not switch off.
Press key P1 once, the display will show the application time
previously set.
All the leds will light up, L2 <time> L3 <set>
To increase or decrease the time, press <+> and <->, the display
increases or decreases each time the keys are pressed.
To decrease the time quickly press and hold <->, then press
the <+> key.
Lower the upper platen to activate a micro switch located
inside the press that controls the time countdown.
The lapsing time is displayed on the screen.
When the countdown is completely 0 a buzzer goes off.
Raising the upper platen, the buzzer stops and the display
shows the temperature again.
Press key P1 again, the display will show the working
temperature set for the upper platen.
The following leds will light up, L1 <Temperature> L3 <set>.
Use <+> and <-> as explained above to increase or decrease the
temperature.
To adjust the pressure, raise or lower the cold lower platen,
rotating it after loosening the lower dowel B (see Fig. page 13).
Remember to fasten the dowel again after making the
adjustment.
Summary of Contents for TS-DOUBLE
Page 74: ... SISER S r l 2019 Notes ...
