Siruba VC008B, Instruction Book / Parts List, Page: 20 / 60

P15
控線強弱必須根據車縫布料層數線的種類與
車縫的針距等不同而做不同之調整。
(
圖
11)
*
將控線鈕順時針方向旋轉時，線越緊，反之
則越鬆。
針控線桿之調整
(
圖
13)
*
針線控線桿
B
依縫線使用種類來選擇使用
之狀態，放鬆螺絲
A
將
B
上下移動調整，
在使用伸展性大的縫線時將
B
上移，反之
下移。
The thread tension strength should be
adjusted differently according to the
fabric,the layers amount of the sewing
fabric,and the stitch length.(Fig.11)
*Rotate the thread control knob
clockwise,and the thread tension will
be tighter.
Otherwise,the tension will be looser.
Adjust the needle thread control
rod(Fig.13)
*Based on thread types to adjust the
needle thread control rod B to the best
using status.Loosen screw A to move
B up or down to adjust.Move B upward
when using high extensibility thread.
Otherwise,move B downward when
using low extensibility thread.
圖
13/Fig.13
2.
在穿勾針線時，應將勾針座引出軸
P
沿箭
頭方向拉出使勾針座向前彈出，然後進行
穿線。
(
圖
12)
2.When threading,the leading shaft of
the looper holder should be pull
out as the arrow direction,so that
the looper holder will slightly move
forward.Then,proceed threading.
(Fig.12)
圖
12/Fig.12