Siruba VC008B, Instruction Book / Parts List, Page: 16 / 60

P11
圖
3/Fig.3
圖
4/Fig.4
1.
依本機器所附桌板裁製圖及零件組合圖
所列之配件，依序安裝防震基座及線架。
(
如圖
3
、圖
4
所示
)
1.Use the accessories of the machine
one by one to install the anti-shock
seat and thread stand as the attached
table cut-out and the parts list showed.
(Fig.3 , Fig.4)
注意：
(1)
桌板厚度約為
45 mm
。
(2)
馬達規格：直驅馬達，單相
4
極
600
瓦特。
NOTE
：
(1)Table thickness is about 45 mm.
(2)The specification of
the motor:direct drive motor,1 phase,4
poles,600 W.
新機器運裝前均已將油倒盡，因此機器使用
前必須加入潤滑油。
1.
潤滑油之注入
(
圖
5):
*
將
A
旋開，以包裝箱內所附之超高速潤
滑油或選用
MOBIL#10
或
ESSO#32
等級
之潤滑油加入，使油窗
C
位於上油標線即
可，然後再裝上
A
。
The oil is empty in each new machine
before shipping.Therefore,it is necessary
to fill the lubrication oil before using.
1.Fill the lubrication oil(Fig.5)
*Rotate & open cover A, and
lubricated with high-speed oil , or
the same level oil such as Mobil#10 or
ESSO#32. The oil must reach up oil
line in oil tank window, then close
cover A again.