- 30 -
BLIND STITCH
Set up position
：
1. Fit blind stitch presser foot.
2. Pattern selection “04”.
3. Stitch length dial at between “1.5-2.5”
4. Needle width dial at “3-5”
5. Loosen upper tension slightly.
1. Fold the material as shown. Make the fold as wide
as you want the finished seam to be: the bottom
fold should be about 5 mm away.
2. Use the blind hem foot. While sewing, check the
seam width and needle setting, to ensure that the
seam remains uniform.
3. Sew the blind seam on the underside of the
material, so that only the peak of the zigzag stitch
pierces the out-side of the material. When you have
finished sewing, push the left of the material over to
the right and smooth out. The seam is almost
invisible!
The table below shows the suggested settings for the
various values, depending on the material used.
04
