9
Roady BT User Guide
Installation
Step 2: Install the Dash or Vent Mount
Follow the instructions on the next several pages for the mounting method you have selected .
Installing the Adhesive Mount
CAUTION!
The adhesive used on the Adhesive Mount may be difficult to remove . Do
not install this mount on leather surfaces (contact your automobile dealership if you
are unsure about your dash surface), and make sure the air temperature is at least
60°F (15°C) during installation . If it’s not at least 60°F, turn on the heater in your
vehicle to bring the temperature up to 60°F .
1.
Locate a flat surface for the Adhesive Mount . Make sure there is ample room for
the Intelligent Vehicle Dock and Roady BT Radio when installed .
2.
Set the orientation of the Adhesive Mount before adhering it . Loosen the knob and adjust the
adhesive foot for the location you selected in “Step 1: Choose a Location for Your Radio” on
page 8 .
3.
The dock mounting plate can be tilted in different directions . Adjust as necessary for your
particular vehicle . When the orientation is correct, tighten the knob .
4.
Remove the adhesive liner from the back of the Magnet and
adhere the adhesive side of the Magnet to the Dash Mount .
5.
Clean the mounting surface in the vehicle with the alcohol
preparation pad and let it dry thoroughly .
6.
Once the surface is dry, remove the adhesive liner from the Dash
Mount . Press and hold the Dash Mount in place for 30 seconds . Allow
the adhesive to cure for 2-4 hours .
7.
Attach the Roady BT Display to the magnet on the Dash Mount .
IMPORTANT!
Allow the Adhesive Mount adhesive to cure (dry) for a minimum of 2-4 hours
before using the mount . The best adhesion occurs after 24 hours .
TIP!
To remove the Adhesive Mount, carefully lift the adhesive pad with your fingers or a
spoon . Warming the pad with a hair dryer for several minutes will help soften the adhesive .
Option 1
Option 3
Option 2
Option 4
Knob
Adhesive Foot
Mounting Surface
for Magnet
