Sirius Satellite Radio SUPV1C Plug & Play, User Manual And Installation

Page: 22 / 44

[
Installation
]
22
bends in the cable, run the cable inside of the weather stripping for a few inches,
then remove the cable from the weather stripping inside of the trunk. Keep the
cable away from hinges, gears, etc., that could damage it.
Route the cable out from the rubber weather stripping and along the trunk wall.
Continue routing the cable into the cabin through a conduit or along an existing
wiring harness.
Route the cable through the main cabin area under the interior trim, towards the
front of the vehicle. Use the plastic putty knife to lift the plastic trim just enough
to tuck the cable under underneath. Avoid side airbag locations on back pillars
and above the doors. (Airbag locations are marked with “SRS” logos.) Be careful
not to crimp or cut the cable.
Bring the cable out from the trim near the firewall and route it under the carpet
toward the dashboard or console. Coil any excess cable in a hidden location,
such as under the carpet, keeping it away from any vehicle pedals or controls.
Secure the excess cable with wire ties.
Bring the end of the cable out at the SIRIUS radio location. Leave yourself
enough cable so you can easily connect it to the antenna connector of the
SIRIUS radio or vehicle dock.
3.
4.
5.
6.