8
Step 1a:
The Filter Cover is held in place via four
magnets. Accessibility to the filters is achieved by
gently pulling down on the cover as per fig.1
Step 1c:
Once the panel is removed, lift the clip of
the filter and pull down to remove them from the
rangehood
Step 1d:
Feed the cables through the four holes
in each corner of the rangehood ensuring that the
la positive and - negative cables go into the
correct holes. Failure to do this may cause damage
to the unit when it is first turned on.
Step 1d:
After feeding the cables through the
rangehood, using the four supplied grub screws,
fix the light into place by allowing the cables to pass
through their centre and tightening them down.
(NOTE: Depending on your circumstance and
accessibility to the cassette, determining the exact
height of the pendant light may be required to do
so prior to fitting the unit to the ceiling)
Step 1b:
This panel will be held on via four cables
to prevent it falling. For installation is is required
to unhook these cables and remove the panel
altogether.
ATTACHING THE PENDANT LIGHT
Fig.1
Fig.3
Fig.4
Fig.5
Fig.6
Fig.2
Summary of Contents for 9351116001353
Page 2: ...2...
