1.0
SIRI MIX
Chapter:
Page:
Release:
9/17
2.2 CORRECT USE OF PERSONAL SAFETY GUARDS
No special protective devices need not to be used by the operator; indeed keeping to the regulations
mentioned before is sufficient.
2.3 INCORRECT AND PROHIBITED USE OF THE MACHINE
The “SiriMix” must exclusively be employed to mix the materials as indicated in section 1.1. Using the
machine improperly can place the gear reducer at risk of halting, thus causing the motor to burn.
Never make alterations to the machine or its mainparts. Alteration are permitted in the S.I.R.I. workshops only.
This rule does not apply to adjustments which prove necessary during operative life of the machine.
These operations must, however, be performed by authorised persons only.
Any adjustments or operations involving the replacement of worn out mechanical parts must
be carried out with the machine disconnected from the power supply.
2.4 INFORMATION ON RESIDUAL RISK FACTORS
The machine presents no residual risk factors, since, as said before, it is not dangerous.
2
G
eneral
noteS
on
Safety
2.1 GENERAL POINTS
Any repair or servicing operations must be carried out with the machine switched off and
disconnected from the power supply.
Do not start up the machine before installing the bucket and lowering the motor.
Read cerfully through the manual before erecting, starting and operating the machine, and before
servicing or adjusting any part of the equipment.
Do not allow unauthorised persons to work on the machine.
Do not wear rings, wrist watches, jewellery, or any other clothing (baggy of loose fitting,
unzipped, unbuttoned or torn) that could catch on moving parts; hair should also be gathered
and tied if particularly long.
Do not occupy or encumber the operating area around the machine.
Never attempt to start the machine when affected by technical problems.
Make certain that any condition posing a possible threat to safety is eliminated before using the machine.
Report any irregularities in operation to site managers or appointed supervisors.
Make certain that all guards and other protective parts are properly in place and that all safety devices
are installed and operational.
Observe procedures and information given in the manual regarding maintenance and customer service.
Do not use petrol, solvents or other inflammable cleaners on the machine.
Use only proprietary solvents certified non-inflammable and non-toxic.
Do not subject the motor with gear reducer to sever stresses due to excessive filling of the bucket
or to improper use.
One person only must operate the machine.
Nobody other than the operator should be allowed in the space immediately surrounding the ma-
chine when cutting.
Do not perform mending operations when the machine is working or connected to the power supply.
Check every day the status of the power cables.
Before connecting the machine to the switch panel, make certain the panel is fitted with a residual
current device.
Before connencting the machine, check that the nominal power supply voltage is the same as the
rated voltage of the machine.
