SIRI 13, Instructions For Use Manual

Page: 16 / 20

1.0
SIRI MIX
Page: Release:
11/17
Chapter:
3
i
nStallation
POSIZ. N° DENOMINAZIONE ART.
1 1 Motoriduttore 13-01
2 1 Supporto motoriduttore 13-03
3 1 Attacco per coperchio secchio 13-09
4 1 Coperchio secchio 13-06P
5 1 Pala mescolatore 13-05
6 1 Telaio porta secchio 13-02
7 2 Ruote D.60 13-35
8 1 Piastra porta secchio 13-07Z
9 1 Leva 30MINI
10 1 Base per interruttore 471RET
11 0,43 Guarniz. Scatola interruttore 226-01
12 1 Scatola interruttore 471MIX
13 1 Interruttore 505-17
14 1 Microinterruttore 13-04
15 1 Molla 13-08
16 1 Secchio LT 40 18-03
17 1 Condensatore 13-90
18 1 Motore 13-30
19 1 Albero motore 254
20 1 Cuscinetto 6203
21 1 Base riduttore 14-21
22 1 Inserti per base -
23 1 Spina cilindrica 243SPI
24 1 Cuscinetto 14-27
25 1 Ghiera per riduttore G12X1
26 1 Ingranaggio primario 253
27 2 Astuccio a rullini 14-26
28 1 Ingranaggio secondario 251
29 1 Piastrino ferma cuscinetto 14-51
30 1 Perno filettato 821-2
31 1 Cuscinetto 14-27
32 1 Cuscinetto 270
33 1 Anello di tenuta 14-17
34 1 Coperchio riduttore 14-022
3.3 ADJUSTING THE MACHINE
The “SiriMix” leaves the factory fully tested; the user has not to perform any adjustments
or fixing operations, except for installing the bucket with wheels (optional extra) as descri-
bed in section 5.5.
3.4 OPERATING PROCEDURES
To carry out any operations with the “SiriMix”, having installed it following the given in-
structions, the user has to proceed as follows:
1 - Insert the plug into the power socket;
2 - Lift the paddle to the second position, disconnecting the lever on the left side of the
machine (Fig.9);
3 - Pour the amount of water as indicated on the glue sack into the bucket;
4 - Pour the contents of a sack of glue into the bucket;
5 - Disconnect the paddle as at point 2 and lower it until the lever gets connected in the
lowest position. Check that the pipe on the right side of the machine blocks the handle of
the bucket (Fig. 8);
6 - Press the button “I” of the switch to set the paddle into motion;
7 - Check that the mxture has reached the desired consistency (otherwise add water or
glue through the slits on the bucket cap);
8 - Revert the switch to the “0” position, letting the paddle stop turning;
9 - Repeat the operation at point 2 to use the mixture;
When the mixture inside the pail is finished, repeat all operations from point 1 to perform a
further working cycle.
NB: when operating:
CAUTION: One person only must operate the machine.
Nobody other than the user should be allowed in the space immediately surrounding
the machine while working.
CAUTION: Daily check power cables of the machines.
Make certain the operator is always free from obstacles
Any adjustments must be carried out with the machine switched off and disconnected
from the power supply.
Do not subject the motor to severe stresses due to excessive filling of the bucket,
incorrect dilution of the glue or improper use of the machine.