TI03-328ENG-REV5
9 of 12
MIX control is turned full right, CAM B is
eliminated (see Figure 6B); turned full left and
CAM A is eliminated (see Figure 6C).
10. Press the DIFF Switch with the MIX control
knob at its midpoint range. CAM A image is
now superimposed on top of a reversed image
of CAM B (see Figure 7A).
NOTE:
This mode
is particularly use-
ful when working
with prints devel-
oped with light-
colored powders.
Adjust the amount
of DIFF by turning
the MIX control clockwise to intensify CAM A image or counterclockwise to intensify CAM B. If
the MIX control is turned full right, CAM B is eliminated (see Figure 7B); turned full left and CAM
A is eliminated (see Figure 7C).
11. Press the FREEZE Switch to capture the current position of CAM B image. Now, you need only to
reposition CAM A image to align. This is especially useful when attempting to superimpose one print
over the other as in the FADE or DIFF modes.
NOTE:
The FREEZE mode actually captures the
image seen with CAM B. In other words, you can remove the ten-print card from the focusing jack
and not loose the previous image you’ve now captured—that is, until you deactivate FREEZE.
The
FREEZE mode can be activated when comparing in L/R, T/B, FADE, or DIFF modes. Remember,
even if you had previously activated EXCH mode, only CAM B image will FREEZE.
12. Press the EXCH Switch to swap CAM A and CAM B images. If the unit is operating in L/R mode,
FIGURE 6B
FIGURE 6C
FIGURE 7A
FIGURE 7B
FIGURE 7C