4 of 8
TI02-134ENG-REV4
5 of 8
BENCH PEDESTAL ASSEMBLY INSTRUCTIONS
Note: Check for damage upon receipt of Fingerprint Bench Pedestal and report any to delivering carrier.
Open all boxes and carefully remove contents. Check against list on back page for all necessary parts to
construct the base. If any parts are missing, contact the factory for prompt service.
1. Carefully unwrap all parts and hardware. Be
sure to work on a piece of carpet, cloth or other
nonabrasive surface.
2. Place the base face-up on the work surface.
Screw the two (2) threaded rods into the base
so that they protrude through the bottom about
1/2" (13mm). Place the column over the thread-
ed rods (Fig. A).
3. Place the mounting plate on top of the column
so the threaded rods protrude through the two
(2) holes in the plate. Insert a lock washer and
an acorn nut on each rod and tighten. Continue
to tighten the acorn nuts which in turn tightens
the rods into the base until entire assembly is
sturdy (Fig. B).
4. Turn the column assembly upside down. Place
a lock washer and hex nut on the threaded
rods and tighten (Fig. C). Return the assembly
upright. Your base is ready to accept the finger-
print bench.
FIGURE A—Place column over threaded rod.
