Siqura CD810F1, Installation Manual, Page: 12 / 18

[12]
4.3 Change network settings
With Siqura Device Manager, you can directly change the network settings of
the CD810F1.
To assign a static IP address
1. Go to the list of detected devices, and then right-click the entry for the
CD810F1.
2. Click Change Network Settings .
3. In C hange Network Settings , click Static IP .
4. Provide the camera with an appropriate IP address, netmask, and
gateway address for the desired network configuration, and then click OK .
5. In the pop-up window indicating that you have successfully changed the
settings, click OK .
6. Wait one minute, and then rescan the network.
7. To access the webpages of the camera, double-click its entry in the list of
found devices.
To assign a DHCP server
1. Go to the list of detected devices, and then right-click the entry for the
CD810F1.
2. Click Change Network Settings .
3. In C hange Network Settings , click Enable DHCP , and then click OK .
4. In the pop-up window indicating that you have successfully changed the
settings, click OK .
5. Wait one minute, and then rescan the network.
6. To access the webpages of the camera, double-click its entry in the list of
found devices.
Note: A DHCP server must be installed on the network in order to provide
DHCP network support.