34
Ref. No.
Description
SIP Part No.
Ref. No.
Description
SIP Part No.
67.
Switch box
WD01-00784
77.
Chuck guard 40mm
66609
68.
Screw (M4 x 6)
WD01-00723
78.
Hex. wrench
WD01-00790
69.
Clip
WD01-00724
79.
Hex. wrench
WD01-00737
70.
Lock washer
WD01-00725
80.
Belt O-490
WD01-00791
71.
Bearing 6201
WD01-00732
81.
Centre pulley
WD01-00792
72.
Quill
WD01-00785
82.
Eccentric shaft
WD01-00778
73.
Washer
WD01-00786
83.
Nut M5
WD01-00697
74.
Circlip
WD01-00787
84.
Screw (M6 x 16)
WD01-00708
75.
Spindle
WD01-00788
85.
Circlip
WD01-00787
76.
Chuck
WD01-00789
PARTS LIST - 01701….cont
27
Cleaning and maintenance of this drill is mainly common sense some points for guid-
ance are as follows:
Regularly check that all the fixing screws are tight.
The mains lead of the drill and any extension cord used should be checked fre-
quently for damage. If damaged, have the mains lead replaced by an authorised
service facility. Replace the extension cord as necessary.
Regularly check and clean out any dust etc. that may have gathered in the fan
housing of the motor.
After each use brush off any chippings etc. with a soft brush.
Regularly check the drive belt for wear; Replace if frayed or worn.
Lubrication:
MAINTENANCE
All bearings are packed with grease at the factory and require no further lubrica-
tion.
Periodically grease or oil all moving parts.
Periodically apply a thin coat of wax paste or light oil on the column, table and
base for lubrication and to help prevent corrosion.
Occasionally, lubricate the quill shaft assembly and rack with light oil if required
(039 & 040).
039
040
Quill Shaft
Rack