6
SAFETY INSTRUCTIONS….cont
Ensure that the pump is connected to the correct supply voltage.
Become familiar with the controls before operating this pump.
Do not attempt to move the pump when it is loaded and/or in operation.
Check all bolts, nuts, pipe fittings and screws etc. before each use.
When maintaining this pump, only the manufacturer’s original replacement
parts may be used.
Do not operate the pump with wet hands.
Ensure that the operator has read and understands the material safety data
sheet (MSDS) for the type of fuel being pumped and that all cautions are ad-
hered to.
Always operate the pump in a well ventilated area to reduce fume build up.
Ensure that the battery is as far away as possible from the pump when connect-
ing the power supply leads.
Do not turn the pump on / off by connecting / disconnecting the supply leads;
Always use the switch on the pump.
Ensure that the switch is in the off position before connecting the power supply
leads.
Never operate the pump for longer than its duty cycle (30 minutes); Allow the
pump to cool for 30 minutes if the pump has been run for the length of its duty
cycle.
Never smoke whilst operating the pump.
Never place the pump where open flames are present.
Never operate the pump ‘dry’ with no fuel running through it; This will damage
the internal components of the pump and invalidate your warranty.
Never operate the pump for more than 2-3 minutes in ‘by-pass’ mode (with the
supply nozzle closed).
Appropriate personal protective equipment, clothing, gloves and safety glasses
etc.
must
be worn and
must
be de-signed to protect against all hazards creat-
ed. Severe permanent injury can result from using inappropriate or insufficient
protective equipment.
Always wear suitable eye protection when using or maintaining the
transfer pump.
19
NOTES
