Sinterit SANDBLASTER XL User Manual | 17
C. REPLACEMENT OF PROTECTIVE RUBBER GLOVES
1. Disconnect the sandblaster from the Power supply
12
and the compressor
14
.
2. Unlock the door
10
with the door ’s lock
7
and open it.
3. To loosen the metal clamp around Protective Rubber Glove
6
, twist off the clamping screw.
4. Gently remove used Protective Rubber Gloves.
5. Clean the surface thoroughly from dirt.
6. Fit the Spare Protective Rubber Gloves.
7. Mount the metal clamp back in place and tighten the clamping screw.
D. MAINTENANCE OF THE VIEWING WINDOW OF THE SANDBLASTER
1. Use a soft cloth or paper towels to clean the sandblaster Viewing window
4
.
2. When the Viewing window
4
itself is damaged, replace it by safety glass with the same thickness and
measurements. Contact with Sinterit Support.
3. Poor visibility inside the sandblaster can be caused by damaged PE protective foil
25
, which is placed over the
Viewing window
4
(inside the chamber). This can easily be replaced by new foil (the five spare PE protective foils
N
are available in additional accessories of the Sinterit SANDBLASTER XL).
•
Remove the old PE protective foil
25
.
•
Clean the inside of the Viewing window
4
with a soft cloth (it is best to soak it with alcohol).
•
Wait until all it dries and carefully place the new PE protective foil
N
.
31
35
23
23
30
28
29
32
33
34
Image. 10. Detailed cross-section through the Static nozzle
19
.
28.Static Nozzle seat / 29.G1/4-45 degree bend / 30.Rubber gasket / 31.Venturi tube / 32.Static Nozzle body /
33.Ceramic nozzle / 34.Nozzle lock nut / 35.Pneumatic tubing connector / 23.Static Nozzle Pnaumatic tubing
