sinmag LBC LMO Max-E, Installation And Service Manual

Page: 12 / 42

© Copyright 2017-2022 LBC Bakery Equipment, Inc. 12 Rev 6/2022
INSTALLATION (Part 2 of 4) .
Uncrating and Moving
1. Move oven to area where it is to be installed. NOTE: If the oven is to be moved through a 36”
door, see section directly below.
2. Disassemble crate. Use caution to avoid damage to oven with pry bars or nail removers.
3. Remove plastic wrap and padding from outside of oven. Remove components from inside of the
oven.
4. Use a fork lift to lift oven off of shipping skid. Slide forks under outer wall of oven. Do not lift at
middle of oven floor. As an alternate method, oven is equipped with lifting eyes on top. Connect
a chain or lifting strap capable of lifting 2000 pounds to the two lifting eyes to raise oven off of
skid. Place oven on floor close to its final location.
Moving the Oven through a 36” Doorway (contact LBC for detailed instructions)
1. Disassemble crate. Use caution to avoid damage to oven with pry bars or nail removers. Remove
plastic wrap and padding from outside of oven. Remove components from inside of the oven.
2. Remove top access cover of oven. Remove four internal hex-head screws between the slats of
forward valance, then tilt access cover forward and lift it out.
3. Open loading doors. Remove door latch cam follower.
4. Remove valance assembly by removing the four screws attaching it to side trim. Slide the valance
forward.
5. Remove top trim.
6. Remove screw attaching magnetic reed door switch to front of oven above control. Allow switch
to hang in position.
7. Remove door assembly.
WARNING
DOOR ASSEMBLY IS HEAVY. USE EVERY PRECAUTION TO AVOID
PINCHING FINGERS. USE ASSISTANCE TO MOVE DOOR ASSEMBLY.
a. Remove the two screws attaching the lower door hinge to the front of the oven on both
doors.
b. Remove the screws connecting the oven floor to the threshold.
c. Remove the four screws connecting the door mechanism to the front of the oven at the top
of the door assembly. Use caution to keep fingers out of pinch points.
d. Carefully move door assembly away from front of oven without tilting it. Wrap door
assembly with stretch wrap, rope or tape to keep doors from opening or moving.
e. Prop door in a safe location. Make sure it will not fall.
8. Gas Ovens: Remove two screws from gas inlet pipe bracket at back of oven. Push gas pipe
forward so it clears door opening.
9. Remove power cord and rear panel from oven.
10. Move the oven through doorway sideways. NOTE 1: Oven weighs more than 1000 lb. If required,
you can remove inner right wall cover and remove steamer mass in four sections. NOTE 2: Oven
floor can be removed if necessary to lift oven from the inside.
11. Replace all components removed in steps 1 through 10.