Revision 1.00
10
Attach Vertical GPU Mount to bottom panel in the position marked in the diagram below using x2
M4 6mm fasteners.
Step 3 - Attach LED Diffusor and LED Shroud to Front Panel
Parts Involved
•
c
Front Panel x1
•
30cm LED Strip x1
•
g
LED Diffusor x1
•
Power Button x1
•
h
LED Shroud x1
•
M4 x 14mm Fasteners x3
Remove the adhesive backing from the LED strip and attach it to the LED strip position highlighted
in the diagram below. Route the cable through the cable routing hole at the bottom of the front
panel. Attach the LED Diffusor and LED Shroud at the same time using x3 M4 14mm Fasteners. Do
not over tighten fasteners on acrylic.
Install the Power Button into hole as shown in the diagram. Use the included O-ring on
the inside of the panel and tighten the retention ring onto it.