24
AEROS Loop Studio: Manual
Settings
DEVICE SETTINGS
Recording source:
Selects which input is recorded. You may select one or both:
●
Main In
●
Aux In
Note:
There must at least one recording source.
Main Input Level:
Sets the impedance for the inputs. Instrument level is about 10%
more sensitive than Line level.
Instrument (1M Ohms impedance)
Line in (50k Ohms impedance)
Audio Output:
Sets whether audio is monitored in Stereo or in Mono
Mono: Audio plays back summed into mono from each output channel. (Warning:
Stereo monitoring, like with headphones, when using this setting will cause
audio to seem twice as loud because the entire signal is sent out both left and
right channels, instead of splitting it between them)
Stereo: Audio plays back split in L/R channels.
Loop playback routing:
Selects where the Loop Playback is sent. You may select one
or both:
●
Main Out
●
Aux Out
Note: The loop playback must be sent to at least one output.
Main input routing:
Selects where the live sound going into the Main Input is sent.
You may select one, both, or neither (the ability to use neither was requested by users
who use a mixer going into the AEROS and want to prevent a 'phasing' effect):
●
Main Out
●
Aux Out
Aux In Routing:
Selects where the live sound going into the Aux In is sent. You may
select one, both, or neither:
●
Main Out
●
Aux Out
Click Routing:
Selects where to send the Click track. You may select one, both, or
neither:
●
Main Out
●
Aux Out
Click after recording first track:
Determines if click will playback always or only
while recording the first track in each song part. If setting is off will only be audible on
first recording pass (Note: if click isn’t routed to either output you won’t hear it).
●
On
●
Off