Singer Sewing Machine, Instruction Manual

Page: 31 / 39

To Thread Bobbin Case
Holding the bobbin case in your left hand, turn the open side up
and place the threaded bobbin into it (Fig. 1).
Guide the thread into the slot in the edge of the bobbin case
(Fig. 2).
Pull it under the tension spring and then into the delivery eye
(Fig. 3).
To Insert Bobbin Case Into The Machine
Raise the needle bar and take-up lever both to their
highest point.
Open the slide plate.
Hold the bobbin case by the latch and place it on the
center post with the bobbin case
fi nger in the notch at
the top of the shuttle.
Release the latch and press the bobbin case into the
shuttle until the latch catches on the center post with
a click.
Permit the thread to hang down freely a few inches.
KEY NO PART NO PART NAME QTY
1 W109 FEED REGULATOR THUMB NUT 1
2 W105 FEED REGULATOR LEVER 1
3 A053B–2 FEED REGULATOR LEVER NUT 1
4 W107 FEED REGULATOR 1
5 FEED REGULATOR SPRING 1
6 B010 FEED REGULATOR SCREW SET SCREW 1
7 W108 FEED REGULATOR SCREW 1
8 A069B FEED CONNECTION SLIDE BLOCK 1
9 A069A FEED CONNECTION SLIDE BLOCK STUD 1
10 B103 FORKED ROD 1
11 A023 FEED ROCK SHAFT CENTER SCREW
FEED LIFTING ROCK SHAFT SCREW &
NUT
2
2
12 W046 DRIVING CRANK 1
13 A071B FEED ROCK SHAFT CRANK 1
14 A071A FEED ROCK SHAFT
15 A076 FEED BAR CENTER SCREW & NUT 2
16 A075 FEED BAR 1
17 W011 FEED DOG 1
18 A078 FEED DOG SCREW 2
19 W046–1 DRIVING CRANK GUIDE NUT 1
20 A061 DRIVING CRANK GUIDE SCREW 1
21 A072 FEED LIFTING ROCK SHAFT 1
22 A073 FEED LIFTING ROCK SHAFT CRANK 1
23 A071B–1 FEED ROCK SHAFT CRANK SET SCREW
FEED LIFTING ROCK SHAFT CRANK SET
SCREW
2
24 A067 FEED REGULATOR SCREW WASHER 1
GROUP 4
10 31
1
W106