Singer Sewing Machine, Instruction Manual

Page: 26 / 39

GROUP 2: SEWING TRANSMISSION GROUP
8 Replace the race cover (C) polished side out so that both pins
are under knobs (A) and (B).
9 Lock the race cover (C) with knobs (A) and (B).
10 Replace bobbin case and bobbin, and resume sewing.
Instructions to repair machine should the Balance Wheel and
Motor run But the Machine will not. (See fi g. 10)
To Remove the Balance Wheel
1 Remove the clutch stop screw.
2 Remove the hand clutch screw
3 Notice position of prongs on clutch washer in slot of balance
wheel bushing.
4 Remove clutch washer
5 Slide the balance wheel off its shaft.
To Install the Balance Wheel & Clutch Knob
1 Slide the balance wheel onto the shaft of the machine.
2 Position the clutch washer at the end of the balance wheel with
the two inner prongs point out.
3 Make note of the position of the outer prongs on the clutch
washer. It may have to be changed later
4 Screw in the hand clutch screw tightly.
5 Screw in the stop screw.
6 Turn the hand clutch counterclockwise as far as it will go (the
screw will hit a stop prong of the clutch washer)
7 Run the motor and check to see if balance wheel turns freely
without running the machine. (the needle should not move)
8 Tighten the hand clutch screw and the machine should run
properly
9 If the clutch is not engaging/disengaging correctly, remove
the clutch washer & rotate clutch washer 1/2 turn and replace.
Repeat steps 4 through 8.
fi g. 10
26 15
10
11