Try power cycling the unit by unplugging it from the wall for 10 seconds and plugging it in again.
Hold the security/reset button down for more than 15 seconds to reset to default setting. The HomePlug AV Ethernet
Bridge’s light will flash, the units will reset and attempt to link using default factory settings.
Try plugging the HomePlug AV Ethernet Bridge into an adjacent plug.
HomePlug AV Ethernet Bridges work better when plugged directly into the wall outlet. Connecting these Ethernet Bridges
to a power strip or surge protector may degrade network performance or completely stop network signals.
This HomePlug AV Ethernet Bridge should not be used on GFI protected outlets as some outlets will filter out HomePlug
Powerline signal.
This HomePlug AV Ethernet Bridge should not be used in areas with excessive heat.
Certain florescent or incandescent lights are noise sources on the electrical and can degrade performance.
If your building has more than one circuit breaker box, your HomePlug AV Ethernet Bridges may not be able to connect
between the different circuit breaker boxes. In this case, connect one HomePlug AV Ethernet Bridge to a power outlet
located on each of the circuit boxes. Connect Ethernet cable between each of the HomePlug AV Ethernet Bridges to link
the different circuits together. This will allow the HomePlug AV Ethernet Bridges from different circuit breaker boxes to
connect.
To enter standby mode for this device, simply remove the Ethernet cable and wait about 3 minutes.
4 Specifications
PLC Module Specification
Chip
Qualcomm Atheros AR7420/AR1540
Protocol
HomePlug AV
IEEE1901
IEEE 802.3 10/100 Ethernet (100Mbps)
IEEE 802.3u Fast Ethernet
Powerline Communication Rate
500Mbps
Signal Band
2~68MHz
Modulation Mode
Support OFDM 4096/1024/256/64/16/8-QAM, QPSK, BPSK, and ROBO
Encryption
128-bit AES
Operation Mode
Support priority-based CSMA/CA channel access scheme
Multicast
Support IGMP management multicast session.
Wi-Fi Module Specification
Chip
Qualcomm Atheros AR9341
Flash Memory
64Mbps
