SINED CALDO-IRA-INOX-2000, Manual, Page: 9 / 12

⑤ Infrared remote control

The distance between the heater and the remote control should be less than
3 meters
and the remote
control should be pointed directly at the receiver.

ATTENTION! The receiver is located near the viewing area and cannot be seen with the naked eye.

Connect the heater to a 230-240V~ 50-60Hz power outlet. Set the rocker switch to position I: the heater
will start operating.
Warning: The remote control cannot operate the heater at this stage.

Insert 2 AAA batteries not included in the infrared remote control. Set the rocker switch to the O
position: the heater is off.

Connect the heater to a 230-240V~ 50-60Hz power outlet. Set the rocker switch to position II, the heater
will start in Standby mode, at this time the "- -" symbol will flash to indicate that the unit is in Standby
mode.

Press the "ON" KEY on the remote control, the heater starts operating at high power (P3);
Press the "LOW", "MED", and "HIGH" buttons on the remote control, the heater will operate with the
LOW and MED, HIGH power settings, and the "P1" "P2" "P3" symbol will be shown on the display area.
P1: 33% of rated power;
P2: 66% of rated power
DISPLAY
(below setting）
(HIGH setting）
(MED setting）