Sinclair SCMI-01.4, User Manual

Page: 4 / 32

- 2 -
2. SAFETY INSTRUCTIONS
WARNING
Please read this manual carefully before installing this device!
 This manual is a part of the product and must be kept near the device to be available
to easily obtain the information.
 This device is not intended to be used for other purposes than those described below.
 Before starting operation, please check the range of operating conditions of the given
installation.
 The SCMI-01.4 control module may be installed only by a company that has the
relevant qualification and is authorized by the manufacturer.

This device is designed for mounting on a DIN rail in a dry and dust-free environment.
Do not allow the water to get into the electrical components; there is a risk of electric
shock or damage to the unit.
 Do not allow persons without the necessary qualification, and especially children, to
manipulate the device.

Cleaning and maintenance may only be performed by persons with the suitable
qualification. Otherwise, personal injury or property damage may occur. Do not
dismantle nor repair the device.

Disconnect the device from the power supply before cleaning or maintenance.
Otherwise, an electric shock may occur.

Do not touch the device with wet hands, do not operate it in a wet environment and
do not wash it with water. There is a risk of electric shock.

Damaged power cables must be replaced by the manufacturer, authorized service
centre or appropriately qualified person.

Do not repair the device yourself. Otherwise, electric shock or damage to the device
may occur. Contact your dealer, if you need to repair the device.

Immediately turn off the device and disconnect it from the power supply, if any of the
following conditions occurs. Then ask your dealer or an authorized service centre for
repair. If you let the device running under these conditions, this may cause a
malfunction, electric shock or fire.
• The power cord overheats or it is damaged.
• An abnormal noise during operation.
• An upstream breaker repeatedly trips.
• The device smells like something is burning.

Ensure that the wires for sensors, load, and power supply are led separately and far
enough from each other, without crossing or parallel leading.