Sinclair MATRIX ASH-18AIM PT, Service Manual, Page: 23 / 96

7HFKQLFDO,QIRUPDWLRQ
6HUYLFH0DQXDO
Replacement of Batteries
1.Remove the battery cover plate from the rear of the remote controller.
(As shown in the figure)
2.Take out the old batteries.
3.Insert two new AAA1.5V dry batteries, and pay attention to the polarity.
4. Reinstall the battery cover plate.
When replacing the batteries, do not use old or different types of batteries,
If the remote controller will not be used for a long time, please
otherwise, it may cause malfunction.
remove batteries to prevent batteries from leaking.
The operation should be performed in its receiving range.
It should be kept 1m away from the TV set or stereo sound sets.
If the remote controller does not operate normally, please take the
batteries out and reinsert them after 30 seconds.If it still can't operate properly,
Notes:
replace the batteries.
Sketch map for
replacing batteries
About Back-lighting Function
21
in HEAT mode to start
The unit lights for 4s when energizing for the first time, and 3s for later press.
8 ℃ Heating Function Nixie tube on the remote controller displays and a selected temperature of
.
“ ”
“8 ℃ ”
(46 if Fahrenheit is adopted). Repeat the operation to quit the function.
Combination of " TEMP " and "CLOCK" buttons : About 8 ℃ Heating Function Press “TEMP” and “CLOCK” simultaneously 20
1
2
3
4
Press "+ " and "- " buttons simultaneously to lock or unlock the keypad. If the remote controller is locked,
is displayed
. In this case, pressing any button, blinks three times.
At unit OFF, press
"
MODE
"
and
" - "
buttons simultaneously to switch between and .
Combination of "+" and "-" buttons : About lock
17
Combination of "MODE " and "-" buttons :
18
About switch between Fahrenheit and centigrade
Press “TEMP” and “CLOCK” simultaneously in COOL mode to start energy-saving function. Nixie tube on the remote controller
displays “SE”. Repeat the operation to quit the function.
Combination of " TEMP " and "CLOCK" buttons : About Energy-saving Function
19