Sinbo SHC 4357, Instruction Manual

Page: 6 / 18

- 5 -
Blade height switch 0.8 mm/1.8 mm
When the switch is in the lower (usual) position, the cutting length is 1.8 mm.
To reduce the cutting length to 0.8 mm set the switch to the upper position.
Universal attachment
The universal attachment has 6 positions for different hair cutting length. It is indicated
on the scale situated on the left side of the hair clipper body:
– universal attachment for 3 mm, 6 mm, 9 mm, 12 mm, 15 mm, 18 mm hair length.
– Switch the unit off by setting the power switch to the position "O" before installing,
removing or changing the universal attachment.
– To install the universal attachment, insert its guides into the corresponding grooves
on both sides of the hair clipper body and slide the attachment as far as it will go to lock
it.
– To adjust the cutting length, turn the adjuster counter/clockwise with your thumb to
set the required hair cutting length according to the scale.
Attention: Do not try to adjust the cutting length with the adjuster during the unit operation,
because when the power switch is set to the position «I», the adjuster is blocked.
Hair thinning function
The unit has the hair thinning function which allows to visually improve the hairstyle by
thinning out hair. Hair thinning makes the hairstyle lighter and accentuates the hair
texture. Due to thinning out the haircut keeps its style for a long time. Hair thinning
means cutting off separate locks. It allows achieving smooth transition between
locks of different length. Hair thinning is performed at the final phase of hair cutting.
To extend the hair thinning comb, move the lock to the utmost right position.
To remove the hair thinning comb, move the lock to the utmost left position.
USING THE HAIR CLIPPER
– For cordless use of the unit, charge the battery fully following the recommendations
above.
Hair cutting
– The hair should be clean and dry.
– Before cutting hair, switch the hair clipper on by setting the power switch to
the position «I».
– Make sure that the hair clipper operates normally and the blades move smoothly.
If there is excess oil on blades, remove it with a dry cloth or a paper tissue.
– Switch the unit off by setting the switch to the position «O», then install the
universal attachment .
– Seat a person so that his/her head is approximately at your eye level, cover the person’s