Sinbo SHC 4357, Instruction Manual

Page: 5 / 18

- 4 -
– Switch the hair clipper off, setting the power switch to the “O” position.
– Insert the power adapter cord plug into the connection socket on the lower side of the
unit body.
– Place the hair clipper on a flat stable surface.
– Plug the power adapter plug into the mains socket, the charging indicator will light
up red.
– The full charging time for the accumulator battery is 10-12 hours; do not exceed it to
avoid reducing the battery operating life.
– After the battery is charged, unplug the power adapter from the mains, remove the
adapter cord plug from the connection socket, the charging indicator will go out.
Attention:
– Strictly follow the sequence of operations when connecting the power adapter. First
connect the power adapter jack to the socket and then connect the power adapter plug
to the mains socket.
– Charge the battery the first 2-3 times for 10-12 hours. The following charging cycle
time should not exceed 8 hours.
– To prolong the battery operating life, it should be discharged completely before each
charging cycle.
– Do not charge the batteries at temperature below +5°C and above +35°C.
– If you have not used the hair clipper for a month or more, charge it completely before
use.
– Never leave the unit connected to the mains unattended.
Lubricating the blade block
Before using the unit for the first time, remove the blade block and lubricate it with oil
(supplied with the unit).
– To remove the blade block, place the clipper with the blades up and press on the upper
edge of the blade block with your thumb to release it from the locking frame.
– The points for applying the lubricating oil are marked with arrows. Apply not more than
1 drop of oil to each point.
– To install the blade block, first insert its lower part into the installation place and then
carefully press on the upper edge of the blades until clicking to lock it.
– Let the hair clipper operate for approximately 30 seconds to spread the oil across the
rubbing surfaces. After that remove the surplus oil with a dry cloth or a paper towel.
Notes:
– Always set the blade height switch to the lower position to avoid difficulties when
installing the blade block to its place.
– Lubricate the blades after every use of the hair clipper.
– Use only the oil supplied with the set.
– Do not use vegetable oil or oil that includes solvents. Solvents will evaporate, leaving
thick grease that may slow down the blades motion.