If you do not want to use this transmitter as the individual control:
- cut the power supply (2 seconds minimum).
- repeat the opération 4.1* with a new transmitter and then go to step §5.
* In this case, the motor will run for 0,5 second in both directions, that means the limits setting is already done.
Programming the first individual control point
Programming a new (individual, group or general) control point
5
6
This operation can only be performed from the
transmitter that was used for operation 4.1.
- Press the transmitter
PROG
button for approximately
one
second
. The motor will run for 0,5 second in one direction
and then in the other.
i
Your transmitter is now programmed to control the motor in stable mode.
6.1- Open the memory of the receiver from the control
transmitter:
- Press the
PROG
key of the transmitter for about
3 seconds.
The motor will run for 0,5 second in one direction and then
in the other.
6.2- Confirm the operation from the new transmitter you
want to program:
- Press the
PROG
key of the transmitter for
1 second
. The
motor will run for 0,5 second in one direction and then in
the other.
- For group controls, repeat operations 6.1 and 6.2 for each motor in the group.
- For general controls, repeat operations 6.1 and 6.2 for each motor in the installation.
- To delete an transmitter from the memory of a motor, perform operations 6.1 with a programmed transmitter,
then perform the operation 6.2 with the transmitter to be deleted.
Recording / controlling / deleting intermediate position
7
Modification of the rotation direction (in user mode):
8
Recording:
- Move the motor to the wanted
position.
- Press
5 seconds
on the
"Stop"
key. The motor will run for 0,5
second in one direction and
then in the other.
Control:
- Press the
"Stop"
key for
0,5 second.
The motor runs to the
intermediate position.
Deleting:
Position the motor on the intermediate position. Press
5 seconds
on the
"Stop"
key, the intermediate
position is deleted.
i
It would be only possible to set or control an intermediate position, after the first two consecutive opening
and closing of the shutter (see §7).
Do not move the roller shutter to the up or down end limit position.
- Press the
"Up" and "Down"
buttons simultaneously
for 5 seconds
.
The motor runs briefly in one direction, then in the other.
-
Within 2 seconds
, press the
Stop button for 2 seconds
. The motor
briefly runs in one direction, then in the other. The rotation direction
has been changed.
After stage 1, if no operation is carried out before 2 seconds, the motor runs again briefly in one
direction and then in the other, and the rotation direction is not changed.
>>
1
PROG 1s.
>>
2
1
PROG < 1s.
>>
1
PROG ≥ 3s.
2
5s
1
2s
2s
2
5s
0,5s
3/4
EN