2/4
4.3- Adjustment of the end-limits - memorizing the end points:
The end limits of the T5EHz are adjusted in
4 different ways
depending on the following conditions :
- Bottom slat stop or not, rigid* or flexible link between the rolling shaft and the shutter.
End limits adjustment
4
If the installation includes several motors, only one motor is to be powered during this programming procedure.
It will avoid interferences with the other motor during the procedure.
>>
ON
2s
1
A
2
2s
1
B
2
3
4
2s
1
C
2
3
4
3s
a
OK
4.3
OK
4.3
b
>>
>>
>>
>>
>>
>>
>>
A
*V.A.R
V.A.S
B
*V.A.R
V.A.S
C
D
4.1- Learning mode:
- Switch ON the motor.
- Simultaneously press the UP and DOWN keys of a Hz transmitter. The
motor will run for 0,5 second in one direction and then in the other.
The transmitter now controls the EHz motor in unstable mode
. Go
to stage 4.2.
1- Simultaneously press the UP and DOWN keys of a Hz transmitter. The motor
will run for 0,5 second in one direction and then in the other.
2- Press the “stop” key for 2 s. The motor will run for 0,5 second in one direction
and then in the other. The operation is completed. Go to stage §5.
1- Move the motor to the UP end limit by using the keys UP or DOWN.
2- To memorize the UP end limit position, press simultaneoulsy the keys STOP and DOWN. The motor will run automatically in
the DOWN direction.
3- Press the STOP key to immobilize the motor.
4- Press 2 seconds the STOP key to confirm the adjustment. The motor will run for 0,5 second in one direction, then in the other
direction. Go to stage §5.
1- Move the motor to the DOWN end limit by using the keys UP or DOWN.
2- To memorize the DOWN end limit position, press simultaneoulsy the keys STOP and UP. The motor will run automatically
in the UP direction.
3- Press the STOP key to immobilize the motor.
4- Press 2 seconds the STOP key to confirm the adjustment. The motor will run for 0,5 second in one direction, then in the
other direction. Go to stage §5.
4.2- Check the rotation direction:
Press the UP key of the transmitter:
a-
If the motorized tube runs in the UP direction , go to next stage (4.3).
b-
If the motorized tube runs in the DOWN direction, reverse the rotation direction by pressing the STOP key for at least 3 seconds.
The motor will confirm the reversal of the rotation direction by running 0,5 second in both directions. Go to stage 4.3.