Simrad TV80, Reference Manual

Page: 231 / 306

406388/B
229
Related topics
Adding a new sensor, page 102
Adding a new sensor that does not need configuration prior to use, page 104
Adding a new sensor that must be configured prior to use, page 106
PX TrawlEye Configurator dialog box, page 229
PX MultiSensor mk2 Configurator dialog box, page 236
Main PX Sensors configuration parameters, page 264
Specific configuration parameters for PX TrawlEye sensors, page 267
Overview of sensors channels and frequencies, page 269
Modifying the parameters of a sensor, page 122
Performing a first time calibration of the roll and pitch measurements of a PX MultiSensor,
page 128
Manually entering the calibration values of the roll and pitch measurements of a PX
MultiSensor mk2, page 130
PX TrawlEye Configurator dialog box
The configurator parameters allow you to set up which measurements the sensor shall
make and which communication channels it shall use for these measurements. When you
configure the PX TrawlEye, you can select the key parameters related to its echosounder,
check the battery status or even configure some special features like the learn mode.
Prerequisites
The
PX TrawlEye Configurator
dialog box is only available if there is a PX TrawlEye
connected to your TV80 by means of the configurator cable. Some features of the
PX
TrawlEye Configurator
dialog box will vary according to the SW version of the sensor itself.
How to open
The
PX TrawlEye Configurator
is opened from the
Add New Sensor
dialog box. To open the
Add New Sensor
dialog box, select
Add New Sensor
at the bottom of the
Sensor list
page.
The
Sensor List
page is located in the
Installation
dialog box. The
Installation
dialog box is
located on the
Setup
menu.
Functions and dialog boxes