Simrad PI DEPTH - MANUAL 2, Instruction Manual

Page: 16 / 36

Simrad PI Remote/Depth
1 To reset the unit, set all six sensors to default sensor type
None .
2 Choose the sensor you wish to use for the PI Spread/Depth
sensor; 1 to 6.
3 Define the sensor type (by default None ) to Dual .
4 Set
Update
to the correct update rate.
5 Set
Measure 1
to the chosen sensor type Spread .
6 Set the communication
Channel
to its correct value.
7 Set
Measure 2
to the chosen sensor type Depth 300M , Depth
600M or Depth 1000M depending on the depth rating on
your PI Remote/Depth sensor.
8 Set the communication
Channel
to its correct value.
9 Press the
ENT
button to save the changes and exit.
All sensors are provided with default communication channels
and update rates. Refer to the table in section
About sensor
configuration on page 14.
About sensor configuration
All sensors are provided from Simrad with predefined
communication channels and update rates.
Default communication channels and
update rates
See the table below for the initial values for the communication
channels and update rates for the various sensors.
Table 1 Default communication channels and update rates
Sensor Com.channel(s) Update rate
PI Bottom Contact 6 Normal
PI Catch 4 Normal
PI Depth (300 m) 16 Fast
PI Depth (600 m) 12 Fast
PI Depth (1000 m) 10 Fast
PI Height 14 Fast
PI Remote/Depth Depth 300M: 11
Depth 600M: 15
Depth 1000M: 13 Fast
PI Spread
2 Fast
PI Spread/Depth Depth 300M: 16
Depth 600M: 12
Depth 1000M: 10
Spread: 2 Fast
PI Twin Spread 2 and 7 Fast
14
316870/A