may be inaccurate or not available at all if the wrong transducer is selected. Transducer
temperature sensors are one of two impedances - 5k or 10k. Where both options are given
for the same model transducer, refer to paperwork supplied with transducer to determine
impedance.
ForwardScan installation
Available when the ForwardScan feature is turned on. For installation and setup information,
refer to the separate ForwardScan documentation.
StructureScan
This feature is automatically enabled when a TotalScan transducer is plugged in before the
unit has been powered on.
You should set the
Structure depth offset
for the structure transducer. This settings is in
the Echosounder Settings dialog.
Radar setup
Use the Radar Installation dialog to setup the radar.
Ú
Note:
The installation can vary depending on the radar. Follow the installation and setup
instructions supplied with the radar.
Radar source
In a system with more than one radar, the correct device to configure can be selected from
this menu.
Ú
Note:
Radars that support dual radar mode are represented twice in the source list, with
an A and B suffix.
Radar status
Scanner type
Identifies the model of scanner connected to the network.
30
Software Setup
| NSS evo3 Installation Manual
