Simrad Maris ECDIS900, Installation Manual

Page: 13 / 64

Page 13
MARIS ECDIS900 Installation Manual
Programs pre-installed:
•
Sensor Monitor with Hatteland Display Controller configured
•
ECDIS900
•
Application Manager
•
TeamViewer
•
CaptureScreenClient
Additional software ready for installation can be found in the folder “Maris Apps” on the
desktop.
IEC 61162-450 COMPLIANCE
SYSTEM FUNCTION BLOCK
ECDIS900 uses UDP communication and datagrams.
NETWORK REQUIREMENTS
All equipment connected to the ECDIS900 network must be tested against the relevant
requirements contained in IEC 60945. See relevant certificates.
ERROR LOGGING FUNCTION
Errors occurring during transmission or reception of route as well as binary files are stored in
two log files titled
61162-450Route.log , and Error61162-450.log . The log files are in the folder
Programdata/MARIS/Log/ECDIS900.
Error logs and error type counters are stored in: C:/Programdata/MARIS/Capture/Capture.ini
Error types:
•
ERROR2: Transmission stopped!
•
ERROR4: ACK ERROR
•
ERROR5: QUERY RECEIVED
•
ERROR6: Corrupted Header error
•
ERROR7: Transmission stopped! Error in header
•
ERROR8: WRONG Destination
•
ERROR9: Non retransmittable route error.
The error log files and error counters are reinitialized every week.
UNIQUE SYSTEM FUNCTION ID (SFI)
The ECDIS900 SFI is coded and stored in the Capture.ini file. It can be edited using the
CaptureScreenClientApp .
MULTICAST GROUP
Open the Capture.ini file using the CaptureScreenClientApp and in the Network and
[ RouteProtocol ] sections enter the IP addresses/port numbers and DestID for the recipients of the
binary file and for route sending.