Installation procedure
Physical installation
The ES70/PI50 Marine Computer is an industrial computer. It is small, rugged, and
contains no moving parts. This means that fans, hard disks and CD drives are omitted.
The computer provides Ethernet sockets, RS-232 serial lines, and a number of USB
connectors. The hard disk is replaced with a solid state drive (SSD).
The Marine Computer is easily mounted with the brackets supplied with the unit.
A small external power supply is provided, and must be placed near the computer.
Figure 1
ES70/PI50 Marine Computer
Preparations
Two brackets and eight bolts enclosed. Mount the two brackets at the bottom of the
computer.
Procedure
To make sure that the procedure is followed correctly, and in the right order, tick off
each task after you have done it.
1
Locate the most convenient location for the computer.
In order to allow for future maintenance, we strongly advice that you mount the
computer with its rear panel available for immediate access.
Note
Make sure that you can access both the rear and front side of the computer after it
has been installed.
2
Observe the outline dimension drawing.
3
Mark the location of the six holes provided on the two brackets.
4
Mount the unit using six bolts or screws.
5
Find a suitable location for the power supply.
6
Secure the power supply with wire straps, velcro, brackets, or any other
means appropriate.
7
Connect the cables.
Note
When you connect the cables, make sure that they are all secured, and able to
withstand the vibration and movements of the vessel.
345266/A
7
