Simrad HS52, Instruction Manual

Page: 23 / 80

INSTALLATION
20222360 / E
15
3.5 Display Unit
Location of the Unit
Avoid mounting the Display unit where it is easily exposed to
sunlight, as this will shorten the lifetime of the display. If this is
not possible, make sure the unit is always covered with the
white protection cover when not used.
The unit is designed for installation in a protected environment
and for operation within the temperature range. The best
location is typically in the instrument room or on the bridge
mounted close to the Processing unit.
Panel Mounting
Two mounting methods may be used when panel mounting the
HS52 Display unit.
A drilling template, part no. 22084883, is supplied with the
HS52 documentation. Use this template when making panel cut-
out and drilling holes.
Gasket
1. Remove the front panel corners.
2. Drill the mounting holes and make panel cut-out according
to supplied template.
3. Use the supplied gasket (part no. 22084693) between the
panel and the unit.
4. Fasten the Display unit to the panel with the supplied 19 mm
screws.
5. Apply the front panel corners.
6. Connect the Processing unit cable to the Display unit
connector.
Caution!
Do not over-tighten the mounting screws.
Alternative Panel Mounting
This way of mounting is simpler, but will lift the unit from the
panel surface. When installed adjacent to Simrad MarineLine
equipment there will be a 5.5 mm (0,22") difference in height
between the Display unit and other equipment.