Simrad GC80 Compact MK2, User Manual

Page: 59 / 156

INSTALLATION
45 988-12720-002
Use the following procedure when remotely mounting the Control panel:
1
Open the Control unit, and remove the wiring strips holding the
Control panel’s cable.
2
Disconnect the cable’s grounding wires (labelled FG) from the
Control panel and from the SCC board in the Control unit.
3 Disconnect the plugs and remove the Control panel’s cable.
4
Loosen the 4 nuts holding the Control panel, and remove the panel.
These nuts are to be re-used when fastening the Control panel to
the flush mounting panel.
5 Insert the Control panel in the flush-mounting kit from the front as
shown in the figure. Fasten the panel using the 4 nuts.
6
Insert the plug on the optional control panel cable, and connect the
grounding wire.
7 Mount the cover on the back side.
8
Fasten the cable to the cover using a wire strip.
9 Slide the Control panel cable through the cable inlet and insert the
plug in the SCC board (J1 – where the internal wires for the Control
panel have been removed). Connect the grounding wire and secure
the cable to the Control unit using a wire strip.
10 Insert the blind cover in the Control unit using the 4 bolts included
in the kit.