Simrad EC150-3C, Installation Manual

Page: 64 / 150

62
438371/A
4 Unpack the transducer from its transport crate. Position the transducer under the
mounting location.
• Unpacking the transducer from its transport crate, page 68
5 Pull the transducer cable up through the steel conduit. Tighten the packing nipple
on the cable gland properly to avoid leaks.
• Installing the transducer cable, page 70
6 Mount the transducer.
• Mounting the transducer, page 72
• Using self-locking taps, page 74
7 Seal the top of the steel conduit to prevent water leaks.
• Using multi-diameter cable sealing, page 77
8 If your vessel will operate in waters with a lot of marine growth, consider applying
a thin layer of anti-fouling paint to the transducer face.
• Painting the transducer face, page 79
9 Install the Power Supply Unit.
• Installing the Power Supply Unit, page 81
10 Connect the transducer cable to the Power Supply Unit.
• Cable layout and interconnections, page 83
Related topics
Drawing file, page 123
Cable layout and interconnections, page 83
Designing, manufacturing and mounting the
installation hardware
Once the physical location of the transducer has been determined, the installation
hardware must be designed, manufactured and mounted.
Prerequisites
Before you can do this task, the following prerequisites must be met:
• All relevant vessel and transducer drawings must be available.
• All relevant work instructions, procedures and standards must be available.
• The physical location of the transducer has been determined.
• The installation method has been determined.
• The cable gland has been installed.
Simrad EC150-3C Installation Manual