Step 5 - Connect Tubing
(refer to page 17 for instructions on use of
Quick Connect Fittings)
Follow the instruction below to connect the SimPure
®
T1-400 Filtration System.
1. Inlet Water---
Remove the transit plug from the
Inlet Water
port.
Use 1/4" white tube to connect the
Feedwater valve
and the
Inlet Water
port.
2. Waster Water---
Remove the transit plug from the
Waster Water
port.
Use 1/4" red tube to connect the
Drain Saddle
and the
Waster Water
port.
3. Pure Water---
Remove the transit plug from the
Pure Water
port.
Use 1/4" Blue tube to connect the
Gooseneck faucet
and the
Pure Water
port.
Step 6 - System Flushing(start up the system)
1.System flushing---
Turn on the Feedwater valve and gooseneck faucet, then
plug in and let the system run for 20 minutes to rinse all fittings and the new
filter. Check for any signs of leaks.
Warning:
Make sure the socket under the sink is powered on, and ensure the
system has been plugged correctly into the power outlet.
Note:
You may notice Black Carbon particles for the first minute, this is normal
2.Enjoy your drinking water---
After flushing, the system is ready for use.
Turn on the faucet and enjoy it.
Note1:
Every time you turn on the faucet, the system will need some time to
dispense water. There may be a 5-second delay before water dispense, which is
normal.
Note2:
There will be some noise when the system is running, this is normal.
The noise will disappear when the faucet is turned off.
Unsure about something? Is there a problem?
Please contact SimPure
®
through our website or toll-free number.
Customer Service:
Toll-Free :1-866-528-4572
Website:
CONGRATULATIONS!
You have completed the installation!
15
16
